Custom IoT hardware,
designed in-house.
From clean-sheet device design to multi-layer PCB layout, prototyping, certification and manufacturing handover. Every IoT-WorkS module pictured was conceived, drawn, routed and shipped by the same UK team.
From schematic to manufacturing pack.
A full hardware project, end-to-end. We don't hand off awkward middle steps to a different vendor.
Schematic design
Component selection, BOM optimisation, simulation where it matters (RF, power).
PCB routing
2 to 8+ layer, controlled impedance, RF tuning, EMC-aware stackup.
Prototyping
First-article assembly, bring-up, test fixtures, design-for-test.
Manufacturing handover
Gerber, BOM, pick-and-place, ATP, contract manufacturer onboarding.
Real tools.
Real chips.
A short list rather than a long one — these are the families we've shipped repeatedly. If you need something exotic, we'll tell you so.
A modular architecture, built and shipped.
We don't recommend a stack we wouldn't run ourselves. Every module below was designed in-house, manufactured to spec, and is shipping to customers. Click any to see the variant we use.
Designed, manufactured, in production.
Not concepts. Not Kickstarter prototypes. The modules we design end up bagged in static-shielding packaging, on a shelf, ready to ship for the next deployment.
Got a device idea? A rough block diagram?
Send what you have. A 30-min call with a hardware engineer is free, and you'll leave with honest scope feedback whether or not we end up working together.